/
(9.3-en) Test Case Quick Execution
Document toolboxDocument toolbox

(9.3-en) Test Case Quick Execution

Owned by Cheney Ma
Jan 18, 2019

You can execute a single Test Case without creating Test Plan & Test Cycle by following these steps:

  1. Open a Test Case issue
  2. From "Ad hoc Test Run" section which is located at the right side of the page, click 'Create' button
  3. Update test result from "Test Case Run" dialog
    Note: If the result is not necessary to be attached to linked requirement/s, please deselect corresponding requirement issue/s from "Covered Requirements" section.
  4. Click "Close" link

[Screenshot - UG0028_Test_Case_Quick_Execution]

5. Once the test execution is done, the result will be recorded to this Test Case.