/
(8.6-en) Trigger Job/Plan from Test Cycle
Document toolboxDocument toolbox

(8.6-en) Trigger Job/Plan from Test Cycle

Owned by Cheney Ma
May 29, 2017

Test Cycle is the space for your test execution, you can either execute your tests manually or trigger your Jenkins/Bamboo job/plan.

To trigger Jenkins/Bamboo job/plan, follow these steps:

  1. Open a Test Cycle.

  2. Expand 'Automation Integration' field.

  3. Choose an "Application" which is configured at Integration Settings
  4. Specify "Plan/Job Key" which can be found from your CI tool
    If Jenkins Job is located in a 'Folder', please follow the pattern '<Folder Name>/job/<Job Name>' for 'Plan/Job Key'.
  5. Click "Add" button

    [Screenshot - UG_AT08_v86_Automation_Add_Job]
  6. Click 'Run' button to start the particular job/plan:

    [Screenshot - UG_AT09_v86_Automation_Trigger_Job]
  7. Once the job/plan is done, 'Executable state' state will change to 'Finished'.
    Note: synapseRT needs maximum 60 seconds to read results from Jenkins/Bamboo after the job/plan is completed, user needs to click 'Refresh' button to get the latest status.

Test Runs those have Automation Tests mapped, and included in the job/plan, will get test results from automation tests after job/plan is done: 


[Screenshot - UG_AT10_v86_Automation_Generate_Results]

Additional settings in job/plan:

Jenkins

synapseRT capture results from xml file artifacts from the Jenkins job, hence please make sure to configure xml artifacts using **/*.xml

[Screenshot - UG_AT11_v86_Automation_Jenkins_Job_Setting]

Bamboo

synapseRT capture results from xml file artifacts from the Bamboo plan, hence please make sure to configure xml artifacts using **/*.xml. 
Copy the xml artifacts to target folder using the configuration under 'Location' as shown in screen shot.

[Screenshot - UG_AT12_v86_Automation_Bamboo_Plan_Setting]