/
Update Test Step Result
Update Test Step Result
You can either update test step result one-by-one, or bulk update all steps result by one click.
Update test step result one-by-one:
- Launch a test cycle
- Click the "Execute" button to open the "Test Case Run" dialog
- In the "Run Steps" section, click the "Pencil" icon from the "Result" column for any step
- Select a result from the drop-down list
- Click the "Close" button to save and close test result, or click "Next" button to save the result and navigate to next test case run.
[Screenshot - UG0054_Test_Cycle_Test_Step_Result]
Bulk update test step results by one click:
- Launch a test cycle
- Click the "Execute" button to open the "Test Case Run" dialog
- In the "Run Steps" section, click any of below item to update all test steps to the corresponding result:
- NOT TESTED: set all test steps to "NOT TESTED" status
- PASSED: set all test steps to "PASSED" status
- FAILED: set all test steps to "FAILED" status
- BLOCKED: set all test steps to "BLOCKED" status
- NA: Not Tested, set all test steps to "NA" status - Click the "Close" button to save and close test result, or click "Next" button to save the result and navigate to next test case run.
[Screenshot - UG0054A_Test_Cycle_Test_Step_Result]
, multiple selections available,
Related content
synapseRT (latest)
synapseRT (latest)
Read with this
(8.5-en) Update Test Step result
(8.5-en) Update Test Step result
More like this
Update Test Case Run Result
Update Test Case Run Result
More like this
(8.5-en) Update Test Case Run Result
(8.5-en) Update Test Case Run Result
More like this
Execute Test Case Run from Test Cycle
Execute Test Case Run from Test Cycle
More like this
Load The Latest Test Cases from a 'ACTIVE' Test Cycle
Load The Latest Test Cases from a 'ACTIVE' Test Cycle
More like this